D-Link DES-3326 User Manual page 278

Setting a Default Gateway
The default gateway parameter defines the IP address of a
router or other network device to which IP packets are to be
sent if destined for a subnet outside of that in which the switch is
operating. This parameter must be set if you are attempting to
manage the switch from a remote network or across the Internet.
1. Starting at the Main Menu of the User Interface, select
Configuration / IP Address.
2. Select Gateway IP from the menu and enter the router
IP address. Press APPLY.
Setting the Administrator Password
Management access to the switch is restricted based on the
administrator password. Administrators have read/write access
for parameters governing the SNMP agent.
therefore assign a password to the default administrator as soon
as possible, and store it in a safe place.
Setting Trap Destinations
If you wish to record SNMP traps, or events, generated by the
switch, you must configure a destination for the IP Trap
Managers. A trap destination is the IP address of the computer
system on which the web-based manager is being run.
1. Starting at the Main Menu of the User Interface,
select Management / Trap receivers.
2. Select an entry for an Trap Receiver from the menu,
then enter the IP address and community name.
262
24-port NWay Ethernet Switch User's Guide
Web-Based Network Management
You should