D-Link DES-3326 User Manual page 205

Figure 6-43. IEEE 802.1Q Multicast Forwarding Settings
The Action:<
Delete using the space bar. To add a new entry to the multicast
forwarding table, select Add/Modify and enter the VID of the
VLAN that will be receiving the multicast packets. Enter the
MAC address of the multicast source, and then enter the
member ports.
Each port can be an Egress, Forbidden, or a Non-member of the
multicast group, on a per-VLAN basis.
To set a port' s multicast group membership status, highlight the
first field of (E/F/-): [ ][ ][ ].
membership can be set individually by highlighting the port' s
entry using the arrow keys, and then toggling between E, F, or –
using the space bar.
E - (Egress Member) specifies the port as being a static
member of the multicast group. Egress Member Ports
are ports that will be transmitting traffic for the
multicast group.
F - (Forbidden Non-Member) specifies the port as not
being a member of the multicast group and that the port
is forbidden from becoming a member of the multicast
group dynamically.
- (Non-Member) specifies the port as not being a member
of the multicast group, but the port can become a
member of the multicast group dynamically.
To setup IP multicasting on the switch:
Highlight IP Multicast Settings from the Multicasting Menu
and press enter.
Configuring the Switch Using the Console Interface
24-port NWay Ethernet Switch User's Guide
> field can be toggled between Add/Modify and
Each port' s multicast group
189