D-Link DES-3326 User Manual page 191

Ingress Filter – this enables the port to compare the
VID tag of an incoming packet with the PVID number
assigned to the port. If the two are different, the port
filters (drops) the packet.
GVRP – Group VLAN Registration Protocol – this
enables the port to dynamically become a member of a
VLAN.
supported on the DES-3326.
GMRP – Group Multicast Registration Protocol – this
enables the port to dynamically become a member of a
multicast group. As of firmware release 1.00-B19, GMRP
is supported on the DES-3326.
Note: Each IP interface on the switch corresponds to a
VLAN.
interface can be setup.
Note: A VLAN that does not have a corresponding IP
interface defined for it, will function as a Layer 2 Only
VLAN – regardless of the Switch Operation mode.
The Layer 3 switch allows ranges of IP addresses (OSI layer 3) to
be assigned to VLANs (OSI layer 2).
configured prior to setting up the corresponding IP interface. An
IP addressing
implemented when the IP interfaces are set up on the switch.
An example is presented below:
VLAN Name
System (default)
Engineering
Configuring the Switch Using the Console Interface
24-port NWay Ethernet Switch User's Guide
As of firmware release 1.00-B19, GVRP is
The VLAN must be configured before the IP
scheme must
VID Switch Ports
1 5, 6, 7, 8, 21, 22, 23, 24
2 9, 10, 11, 12
Each VLAN must be
then be established, and
175