D-Link DES-3326 User Manual page 212

24-port NWay Ethernet Switch User's Guide
Figure 6-48. PIM-DM Interface Configuration
Enter the name of the IP interface for which PIM-DM is to be
configured in the Interface Name:[
previously defined IP interface. See Setting up IP Interfaces,
Chapter 6 of this manual for more information.
Note: The Protocol Independent Multicast – Dense Mode
(PIM-DM) protocol should be used in networks with a low
delay (low latency) and high bandwidth as PIM-DM is
optimized to guarantee delivery of multicast packets, not
to reduce overhead.
The Hello Interval:[30
65535 seconds and determines the interval between sending
Hello packets to other routers on the network.
messages are used by the router to determine if it is the root
router on the delivery tree or not. If the router does not receive
a Hello message within the Hello Interval, it will begin
196
] field allows an entry of between 1 and
Configuring the Switch Using the Console Interface
] field. This must be a
The Hello