About Vga, Mouse And Keyboard Configuration Parameters; Using A Vga Monitor With The Vs-2480; Configuring Your Monitor; Vga Parameters - Roland VS-2480 Tip Sheet

About VGA, Mouse and Keyboard Configuration Parameters
Once you've powered up, you'll want to make sure your mouse, keyboard and VGA
monitor are properly configured. All of the parameters for these devices—described in
the following sections—are found on the same UTILITY Menu page. To get there:
1. Press UTILITY.
2. Press PAGE—if necessary—until SYSTEM appears above F1.
3. Press F1 (SYSTEM).
4. Press F2 (Param2).
5. Press " , # , $ and/or % to select each desired parameter and turn the

Using a VGA Monitor with the VS-2480

Configuring Your Monitor

VGA Parameters

Parameter:
VGA OUT
REFRESH RATE
H. POSITION
V. POSITION

Elements of the Info Display

Most of the VS-2480 Info Display's screens are divided into four areas.
The Info Display also provides a date and time readout in its upper right-hand corner.
8
TIME/VALUE dial to set its value.
What it sets:
Turns the VGA output on or off
Sets the amount of monitor flicker
Shifts the image left or right
Shifts the image up or down
©2001 Roland Corporation US
Typical setting is:
On
Manufacturer's
recommended setting,
or highest value that
looks good on monitor
0
0
General Information Strip
PAN/AUX SEND 1-8 Strip
Meters Strip
Bottom Pane
VS-2480 Tip Sheet