Testing The Complete Configuration; Testing Port Network Equipment - Avaya G650 Installing

8

Testing the complete configuration

This section provides tests for the complete configuration, including the control and signaling networks
and the telephones and consoles.
This section provides tests to:
•
review the status of the configuration.
•
test the IP server interfaces, expansion interfaces, and TDM buses in the port networks.
•
test the telephones and other equipment.
See LED indicators
Ethernet switch(es), uninterruptible power supplies (UPSs), and different circuit packs.
NOTE:
Circuit pack positions are usually given by cabinet, and slot. They may also be given by
port. The term "cabinet" refers to five G650 Media Gateway TDM-cabled together in a
rack, making up one port network. A port network is defined as a group of media
gateways connected together with one TDM bus.
Perform these tasks to test the configuration:
CAUTION:
To prevent unnecessary trouble tickets, do not enable the alarms (Alarm Origination
feature) until all installation and administration procedures are completed.
•

Testing port network equipment

1
Checking port network status for each media gateway
2
Checking circuit pack configuration
3
Testing the TN2312AP/BP Internet Protocol Server Interface circuit pack
4
Testing Expansion Interface circuit packs, if used
5
Testing time division multiplexing bus for each port network
6
Testing expansion interface exchange, if used, for each port network
7
Testing telephones and other equipment
Testing port network equipment
These tests verify that the time division multiplexing (TDM) cables and terminators work. If a FAIL
Result code is seen, check these cables. If problems persist, see the maintenance book for your
configuration .
Installing the Avaya G650 Media Gateway
June 2004
on page 219 for information regarding the LED status indicators for the Avaya
on page 207
Testing the complete configuration
on page 208
on page 210
on page 212
on page 213
on page 215
on page 211
on page 213
207