Connecting A Typical Telephone - Avaya G650 Installing

Table 17: Connectable telephone and consoles 2 of 2
Telephone and console models
603F Avaya Callmaster IV
607A Avaya Callmaster V ACD Console
606A Avaya CallMaster VI ACD Console
Softphones:
Netmeeting H.323
IP Softphone
CentreVu IP Agent
Softconsole

Connecting a typical telephone

The 302D Enhanced Attendant Console is used to describe a telephone connection typically used with the
84xx (4-wire) telephones.
The 302D does not require auxiliary power unless it has a 26C1 DXS console or Vacuum Fluorescent
Display. The 302D attendant console always requires auxiliary (adjunct) power (-48 VDC). Power is
connected to the console through Pins 7 and 8 of the information outlet. Only three consoles can be
powered by the media gateway. When possible, the primary console should be powered from the media
gateway so it has the same power failure backup as the media gateway.
The maximum cabling distance for the console powered from the media gateway is 350 feet (100 meters).
The general steps to connect a telephone are:
1
Choose a device to connect such as a 302D Attendant Console.
2
Choose the port circuit pack and its slot number, such as cabinet 1, slot 02.
3
Choose a port circuit on the port circuit pack, such as Port 05.
4
Install cross-connect jumpers to wire the terminal to the port circuit pack. See
4-wire DCP wiring,
pack.
CAUTION:
Do not use the 329A power unit for the attendant console. Use an 1151B1, 1151B2,
1145A, or MSP-1 power unit.
5
For terminals needing adjunct power, wire -48 VDC and ground to appropriate pins on the
terminal. See
Installing the Avaya G650 Media Gateway
June 2004
on page 156. This pinout is for the TN754C DCP Digital Line 4-wire circuit
Figure 76, 302D to 4-wire DCP wiring,
Installing and wiring telephones and trunks
Type
Digital
Digital
Digital
Internet Protocol (IP)
Figure 76, 302D to
on page 156.
155