Pre-Installation Setup - Avaya G650 Installing

Pre-installation setup

The following information is included in this installation procedure:
•
Pre-installation setup
•
Installing the media gateways on page 23
•
Installing the G650 Media Gateway
•
Installing an MCC1 Media Gateway
•
Installing the G350 Media Gateway
•
Installing the G700 Media Gateway
•
Installing the main distribution frame
•
Connecting the media gateway to the main distribution frame
•
Connecting to the customer's network
•
Installing and wiring telephones and trunks
•
Testing the complete configuration
Pre-installation setup
The pre-installation team should have done the following tasks. If they were not all done, do not continue
with the installation.
•
Verify that the open, customer-supplied, EIA-310D (or equivalent) standard 19-inch (48-
centimeter) equipment racks are properly installed and solidly secured. Make sure that the screws
that come with the racks are there.
•
Verify that the rail kits, required to support the very heavy UPSs, are installed on the rack or
available for installation. For information on installing the rails, refer to the documentation that
comes with the rail kits.
•
Verify that the 19-inch (48-centimeter) EIA-310D open equipment rack(s) is(are) grounded. See
the job aid titled Approved Grounds (555-245-772).
•
Verify that you have the required, customer-provided network information in hand. See the filled-
out Excel spreadsheet titled Electronic Preinstallation Worksheet (EPW). See the Avaya
Installation Wizard Web site (http://support.avaya.com/avayaiw) for the blank form.
•
Verify that you have all the equipment on site. See
and Checking circuit packs
20
on page 20
on page 29
on page 56
on page 94
on page 96
on page 101
on page 149
on page 153
on page 207
on page 32 for the list of required hardware.
on page 117
Installing the G650 Media Gateway
Installing the Avaya G650 Media Gateway
on page 29
June 2004