Testing Telephones And Other Equipment; Making Test Calls; Testing 302C Attendant Console - Avaya G650 Installing

Testing telephones and other equipment

This section describes how to test the telephones and other equipment. Perform these tests after the
equipment has been wired to the media gateway and after the customer's data for that equipment has been
administered. The tests are acceptance tests and provide some assurance that the system will perform
properly after installation and administration.
If problems occur or more extensive tests are required, see the maintenance book for your configuration .
Perform these tasks to complete acceptance tests:
•
Making test calls
•
Testing 302C attendant console
•
Testing selector console
•
Testing external ringing
•
Testing queue warning indicator
•
Testing integrated announcement
•
Testing music-on-hold
•
Testing emergency transfer (Avaya S8700 Multi-Connect only)
•
Testing terminating trunk transmission
•
Testing connectivity to the LAN

Making test calls

Make two calls from one telephone to another telephone. Make the first call by dialing a telephone and
make the second call by dialing a trunk access code and a listed directory number (LDN).

Testing 302C attendant console

To check that all lamps are operational and call another telephone in the configuration:
1
Simultaneously press and hold Ringer Volume up and POS BUSY.
This puts the console in the self-test mode.
NOTE:
Releasing the buttons returns the console to normal mode.
2
Verify all lamps on display light and remain lighted.
Each row of lamps on the console lights and goes dark in sequence from top to bottom.
3
Press Start and listen for dial tone.
The green lamp associated with Idle Call Appearance lights up.
The Position Available lamp goes dark.
Installing the Avaya G650 Media Gateway
June 2004
on page 215
on page 215
on page 216
on page 216
on page 216
on page 216
on page 217
on page 218
on page 218
Testing the complete configuration
on page 217
215