Connect Power Distribution Unit External Alarm Wires - Avaya G650 Installing

Connect Power Distribution Unit External
Alarm Wires
The external alarm plug should already be connected to the J58890CH-1 Power Distribution Unit. The
pinout for the connector is shown in
NOTE:
RS232 alarms (RXD, DTR, DSR, TXD, RS-232 GRD, and RTS) are not supported on the
BU3200A Battery Interface Unit.
To connect the power distribution unit external alarm wires:
1
Choose an alarm to connect (such as Battery Interface Failure).
2
Choose the port circuit pack to use and its slot number (from
telephone pin designations,
3
Choose a port circuit on the port circuit pack, for example port 3.
4
Install cross-connect jumpers to connect the named pins from the alarm wires to the appropriate
pins on the port circuit pack.
NOTE:
Avaya recommends that the RFA, ACF, and BIF alarm leads be connected to the major
alarm device and the BOD alarm leads be connected to the minor alarm device.
5
Connect the major and minor alarm devices to the appropriate cross-connect pins on the MDF.
6
Administer the alarms using the Administrator's Guide for Avaya Communication Manager (555-
233-506).
Table 27: External alarm connector pinout 1 of 2
26 Not Used
1 Not Used
27 Not Used
2 Not Used
28 Not Used
3 Not Used
29 Not Used
4 Not Used
30 Not Used
5 Not Used
31 Not Used
6 Not Used
32 Not Used
7 Not Used
37 Not Used
15 Not Used
Installing the Avaya G650 Media Gateway
June 2004
Installing and wiring telephones and trunks
Table 27, External alarm connector pinout,
on page 173). For example, TN2183 Analog Line, cabinet 1, slot 1.
on page 171.
Table 28, Port circuit pack and
171