Mounting 110A- Or 110P-Type Terminal Blocks On The Wall - Avaya G650 Installing

Each label identifies two rows on the terminal block. The upper half identifies the row above it and the
lower half identifies the row below it. The labels are inserted into the clear plastic designation strips
furnished with the terminal blocks. The strip is snapped in place between the terminal block rows. Label
code number 1220A (comcode 103970000) contains all of the required labels.
Figure 49: Label graphic symbols and nomenclature
Figure notes
1 Floor or Building Identification (write as
required
2 Media Gateway
3 Carrier (leave blank for G600 Media
Gateway)
4 Slot
Mounting 110A- or 110P-type terminal blocks
on the wall
The 110A-type terminal blocks can be stacked in almost any arrangement at any height or location on the
wall. Figure 50, 110A-type terminal blocks (300-pair),
between the mounting screw holes on the terminal blocks is 10.8 inches (27.4 centimeters). If a vertical
patch cord trough is used, the distance between the mounting screw holes is 5.31 inches (13.3
centimeters).
With 110P-type terminal blocks, the first block of the trunk/auxiliary field is aligned with the left side of
the media gateway. See
allows for growth on the right side of the MDF.
To mount 110A- or 110P-type terminal blocks:
1
Route the cables from the rear of the media gateway stack to the MDF via the Cable Slack
Manager. See
Installing the Avaya G650 Media Gateway
June 2004
Figure 51, 110P-type terminal blocks (900-pair),
Installing Cable Slack Managers
r758422i LJK 050996
5 Information Outlet
6 Site/Satellite Closet
7 Tie Circuit
8 Floor
9 Building
on page 111 shows one arrangement. The distance
on page 112. This arrangement
on page 113.
109