Avaya G650 Installing page 60

10
Position the media gateway over the holes and adjust the leveling legs until the media gateway is
level.
11
Insert the threaded rods through the media gateway bottom and thread into the concrete floor
anchors.
12
Place a 3/8-inch flat washer onto each rod. Thread a 3/8-16 hex nut onto each rod and tighten
securely.
13
Repeat this procedure for each media gateway to be installed (including the auxiliary cabinet, if
required).
Figure 16: Earthquake mounting — raised computer floor
60
NOTE:
If the media gateways are supplied with cable ductwork, the media gateways must be level
from front to rear and from side to side. They must be square with respect to each other to
within +-1/8-inch (0.3-centimeter).
4 inches
(10.16 cm)
raised variable
floor height
concrete
subfloor
3/8 - 16
threaded rod
3/8 - 16
Concrete floor
anchor
cab_base CJL 052096
Installing the Avaya G650 Media Gateway
3/8 inch
flat washer
Nut welded
to frame
Leveling
foot
June 2004