Changing Values In The Tsetup Menu; Accepting Changes And Exiting System Setup; Default Configuration - Toshiba SATELLITE 2610 Series User Manual

Changing values in the TSETUP menu

1. Press
move between items in a column.
2. Press either the space bar or BkSp to change the value.
3. Press PgUp or PgDn to change pages.
On either page, you can go directly to a specific group by pressing the
first letter (highlighted) of the group's name. For example, press B to go
to the Battery group.

Accepting changes and exiting SYSTEM SETUP

1. Press End to accept the changes you made.
If the changed item does not require the system to reboot, the
following message is displayed:
If the changed item requires the system to reboot, the following
message is displayed:
2. To make other changes, press N. Repeat the steps above.
3. To accept the changes, press Y.
You can press Esc to quit at any time without saving changes. TSETUP
asks you to confirm that you don't want to save your changes.

Default configuration

When you access TSETUP, the current configuration is displayed.
1. To show the default configuration, press Home.
2. To accept the default settings, press End and then press Y.
When you execute the default setting, the following settings are not
changed:
• Hard Disk Mode
• Password
• Write Policy
User's Manual
and to move between the two columns. Press
Are you sure? (Y/N)
Are you sure? (Y/N)
The changes you made will cause the system to
reboot.
and
Setup and Password Security 8-17
to