Retaining Data With Power Off; Extending Battery Life; Replacing The Battery Pack; Removing The Battery Pack - Toshiba SATELLITE 2610 Series User Manual

Retaining data with power off

When you turn off your computer with fully charged batteries, the
batteries retain data for the following approximate time periods:
Battery pack
RTC battery

Extending battery life

To maximise the life of your battery pack:

 If you have extra battery packs, rotate their use.

 If you will not be using the system for an extended period, remove
the battery pack.

 Store spare battery packs in a cool dry place out of direct sunlight.

Replacing the battery pack

When the battery pack reaches the end of its operating life you will
need to install a new one. The life of the battery pack is generally about
500 recharges. If the Battery indicator flashes orange shortly after fully
recharging the battery, the battery pack needs to be replaced.
You might also replace a discharged battery pack with a charged spare
when you are operating your computer away from an AC power source.
This section explains how to remove and install the battery pack.

Removing the battery pack

To replace a discharged battery, follow the steps below. Refer to
Chapter 2, The Grand Tour, for component locations.
When handling battery packs, be careful not to short circuit the
terminals. Also do not drop, hit or otherwise apply impact; do not
scratch or break the casing and do not twist or bend the battery pack.
If you are using Windows 98, do not remove the battery pack while the
computer is in Standby mode. Data is stored in RAM, so if the computer
loses power it will be lost. It is a good idea to save your data before
shutting down the computer in Standby mode.
1. Save your work.
2. Turn the computer's power off. Make sure the Power indicator is off.
3. Remove all cables connected to the computer.
4. Turn the computer upside down.
6-8 Power and Power-Up Modes
4 to 5 days
1 month
User's Manual