Toshiba SATELLITE 2610 Series User Manual page 70

Fn
Power up mode: Pressing Fn + F3 changes the power up mode. When
you press these hotkeys, the current setting will be displayed in a
window. In a Windows 98 environment, use the When I press the power
button feature of System Power Mode tab in Power Saver. This function
changes the power up mode only when you start the computer by
pressing the power button.
Fn
Alarm volume: Press Fn + F4 to adjust the alarm volume to off, low, medium
or high. The first time you press Fn + F4 the volume is set to off. Continue
holding down Fn and press F4 again to change the setting. A beep sounds
to let you know the current alarm volume. The volume at power on
depends on the latest setting. See Chapter 8, Setup and Password Security.
Fn
Display selection: Pressing Fn + F5 changes the active display device. As
indicated in the table below, the changes depend on the computer's display
type, current setting and whether you have an external monitor connected.
No DVD model
LCD only     LCD/CRT     CRT only     (back to LCD only)
DVD model
LCD only     LCD/CRT     CRT only     LCD/TV     TV only     (back to LCD only)
Do not connect a TV to the video-out jack and a monitor to the external
monitor port at the same time. If two devices are connected at the same
time, they will not display properly.
The LCD/TV setting can be selected only when the computer is in dual mode.
To set this mode, follow the steps below.
Click Start, point to Settings and click Control Panel.
Double-click the Display icon to open the Display Properties
window.
Click the Settings tab and click the Advanced button.
Click the Display Device tab and click the Enable Different
Refresh Rate check box.
If MS-DOS mode is selected, the LCD/TV options will not be available
even on a DVD model.
If a television is connected to the computer, set the TV type in the
Hardware Setup.
User's Manual
F3
+
F4
+
F5
+
The Keyboard 5-5