Diagnostic Test; Executing The Diagnostic Test Program - Toshiba SATELLITE 2610 Series User Manual

Diagnostic test

The diagnostic test program checks system components to help you
determine the cause of the computer's problem.

Executing the diagnostic test program

To start the diagnostics, follow these steps:
1. Check all cables for loose connections.
2. Select Restart (the computer) in MS-DOS mode? from the
Shut Down window.
3. Be sure the computer is not in virtual 86 mode. The test will not run
in that mode. If you try to run the test in virtual 86 mode, the
following message will be displayed:
If the preceding message is displayed, remove memory managers
from your config.sys file. See your MS-DOS documentation for
information on the config.sys file.
4. Go to drive C and at the DOS prompt C:\>, type TDIAGS. MS-DOS
loads the diagnostic test and displays the following screen:
5. To execute the program type Y; to exit, type N.
User's Manual
Cannot execute in a virtual 8086 mode.
TOSHIBA personal computer xxxx DIAGNOSTICS
version x.xx (c) copyright TOSHIBA Corp. 19xx
Test the DIAGNOSTICS (Y/N)
Troubleshooting 10-17