Ps/2 Mouse - Toshiba SATELLITE 2610 Series User Manual

Do not connect a TV to the video-out jack and a monitor to the external
monitor port at the same time. If two devices are connected at the same
time, they will not display properly.
The LCD/TV setting can be selected only when the computer is in dual mode.
To set this mode, follow the steps below.
Click Start, point to Settings and click Control Panel.
Double-click the Display icon to open the Display Properties
window.
Click the Settings tab and click the Advanced button.
Click the Display Device tab and click the Enable Different
Refresh Rate check box.
If MS-DOS mode is selected, the LCD/TV options will not be available
even if a DVD model.
If a television is connected to the computer, set the TV type in the
Hardware Setup.

PS/2 mouse

Use the PS/2 mouse/keyboard port on the computer.
Make sure the mouse has a cable with a 6-pin connector for the PS/2
mouse port. If the mouse's cable is not compatible, see your dealer for
an adaptor cable.
How the computer treats the connection to a PS/2 mouse depends on
the setting for Pointing Devices under the Hardware Setup or
TSETUP program. If Simultaneous is selected, you can operate both
the AccuPoint II and a PS/2 mouse. However, the scroll buttons on the
PS/2 mouse might not work. If Auto Selected is chosen, the
AccuPoint II is disabled when a PS/2 mouse is connected.
To connect a PS/2 mouse:
1. Turn the computer off.
2. Connect the PS/2 mouse to the PS/2 mouse/keyboard port on the
computer, pressing gently to assure a firm connection.
3. Turn on the computer.
To disconnect the mouse, turn off the computer and pull out the mouse
connector.
Consult your mouse manual for instructions on how to install necessary
software.
User's Manual Optional Devices 9-11