Pointing device
If you are using a PS/2 or serial mouse, also refer to Chapter 9, Optional
devices, and to your mouse documentation.
AccuPoint II
Problem
On-screen pointer
does not respond to
AccuPoint II operation
PS/2 mouse
Problem
On-screen pointer
does not respond to
PS/2 mouse operation
10-12 Troubleshooting
Procedure
If a PS/2 mouse is connected, check the
Hardware Setup or TSETUP program. The
Pointing Device option should be set to
Simultaneous to use both the AccuPoint and a
PS/2 mouse.
If problems persist, contact your dealer.
Procedure
Check that the PS/2 mouse cable's 6-pin
connector is firmly connected to the
mouse/keyboard port.
You may have connected the mouse after
turning the computer on. Turn off the computer,
make sure the mouse is firmly connected and
turn the computer back on.
Is your software configured to recognise the
mouse? Check the software documentation.
If problems persist, contact your dealer.
User's Manual