Konica Minolta BIZHUB PRO 1050 Operator's Manual page 403

Adjustment
Procedure
1
Touch [Adjustment] - [02 Finisher Adjustment] - [02 Multi Folder
(Punch) Adj.].
2
Touch [02 Hole-Punch Vertical Position Adjustment] to display the
Hole-Punch Vertical Position Adjustment Screen.
3
Touch the [COPY] tab to display the Copy Screen.
4
Load the desired size of paper to be adjusted on a tray, specify
[Punch], then press [Start]. A sample pattern (No. 16) will be output.
5
Check the distance (a) from the edge of the feeding sheet to the centre
position of the punch hole.
6
If the desired result cannot be obtained, touch the [ADJUSTMENT] tab.
7
Touch [Next] or [Back] to select the paper size to be adjusted.
Touching [Next] continuously will change the paper size as follows.
All - 11x17 - A3 - B4 - 8.5x14 - A4R - 8.5x11R - B5R - 8.5x11 - A4 -
A5R - B5 - A5 - 5.5x8.5 - 8x13 - 8.12x13.2 - 8.5x13 - 8.25x13 - 8K -
16K - 16KR - 12x18
8
Select the desired hole type.
9
Use the touch panel keypad to enter the desired adjustment value, then
touch [Set].
Available range: -40 (wide) to +40 (narrow), 1 step = 0.1 mm
10
Repeat the adjustment steps from 3 to 9 until the desired result is ob-
tained.
bizhub PRO 1050
a
13
13-33