The Copier Is Not Functioning As Designed - Minolta Di250 Manual

6
6.2

The copier is not functioning as designed

Symptom
The Touch Panel shows
nothing.
The Start key does not light
up green.
No copies are fed out when
the Start key is pressed.
Control panel keys do not
respond.
The copier is not activated
when the Power Switch is
turned ON.
* If these procedures do not correct the problem, turn OFF the Power Switch, unplug the
power cord from the power outlet, and contact your Technical Representative.
6-4
Check for
Is only the Start key lit up
green?
The Power Switch is turned
OFF.
The Display Contrast Knob is
turned to the excessively
light or dark position.
Is your Access Number or
Account Number entered?
1166P168CB
The copier has developed a
malfunction.
The copier was just turned
ON and is warming up.
The Interrupt key LED is lit
up.
1166O260AA
The power cord is left
unplugged from the power
outlet.
The room circuit breaker is
open.
Troubleshooting
Action
The copier is in the Energy
Saver mode or the LCD
Back-light is off. Press any
key on the control panel to
cancel.
Turn the Power Switch ON.
Viewing the Touch Panel,
adjust the Display Contrast
Knob as necessary.
Enter your Access Number
or Account Number by
following the procedure
given in "Entering the Access
Number", see page 2-37.
Check the Touch Panel and
take action according to the
message on the panel.
It takes the copier 60 to 70
sec. to be ready for making
copies after it has been
turned ON. Please wait.
The copier is in the interrupt
mode. Press the Interrupt
key to cancel the interrupt
mode.
Plug the power cord into the
power outlet.
Close the room circuit
breaker.
Di250/Di350