Minolta Di250 Manual page 10

l
Always unplug the power cord when the copier is not going to be used
for a long time.
l
Never place a heavy object on the power cord, or pull or bend it, as a
fire or electrical shock can result.
l
Always ensure that the copier does not sit on or roll onto the power
cord or communications cable of other electrical equipment, as
malfunctioning equipment or a fire could result.
l
Always ensure that the power cord or communications cable of other
electrical equipment does not become wedged into the copier
mechanism, as malfunctioning equipment or a fire could result.
l
Always use the correct power voltage, as improper voltage can cause
a fire or electrical shock.
l
Never use a multiple outlet adapter, as a fire or electrical shock can
result.
l
Should the power cord become damaged, immediately turn the copier
off, unplug the power cord and call your technical representative. A
damaged cord can result in a fire or cause an electric shock.
l
If an extension cord is needed, use one with a greater rated capacity
than the maximum power requirements of the copier. The use of an
extension cord that falls short of supporting the maximum power
requirements can result in overheating or a fire.
l
Always unplug the copier whenever anything unusual is observed
during operation. Make sure that the outlet is nearby and clear of the
copier and furniture.
l
Never touch the electrical contacts inside the right door and
underneath the Imaging Unit, as an electrostatic discharge may
damage the copier.
X-2
Electrical Contacts
1166O264AB
Di250/Di350