The Copier Is Not Functioning As Designed - Minolta EP2080 Operator's Manual

130

2. The Copier is not functioning as designed

Symptom
The Touch Panel shows nothing.
The Start key does not light up
green.
No copies are fed out when the
Start key is pressed.
Control panel keys do not respond. The Interrupt key LED is lit up.
The copier is not activated when
the Power Switch is turned ON.
If these procedures do not correct the problem, turn OFF the Power Switch, unplug the power cord
*
from the power outlet, and contact your Technical Representative.
Check for:
Is only the Start key lit up green?
Auto Shut Off is activated.
p.
The Display Contrast Knob is
placed in the excessively light or
dark position. p. 16
Is your Access Number entered?
1149O271CA
The copier has developed a
malfunction.
The copier was just turned ON and
is warming up.
The power cord is left unplugged
from the power outlet.
The room circuit breaker is open.
Action
The copier is in the Energy Saver
mode.
Press any key on the control panel
to cancel Energy Saver.
Turn the Power Switch ON.
Viewing the Touch Panel, turn the
Display Contrast Knob as
necessary. p. 17
Enter your Access Number by
following the procedure given in
"Entering the Access Number."
p. 22
Check the Touch Panel and take
action according to the message on
the panel.
It takes the copier 60 sec. to be
ready for making copies after it has
been turned ON.
Please wait.
The copier is in the interrupt mode.
Press the Interrupt key to cancel
the interrupt mode.
Plug the power cord into the power
outlet.
Close the room circuit breaker.