Using The Copier Properly; Di250/Di350 - Minolta Di250 Manual

Using the Copier Properly

To ensure the optimum performance of the copier, follow the precautions
listed below.
l
Never place a heavy object on the copier.
l
Never subject the copier to shocks.
l
Never open any doors or turn the copier off while the copier is making
copies.
l
Never bring any magnetized object near the copier.
l
Never use flammable sprays, liquids or gases near the copier.
l
Never modify the copier, as a fire or electrical shock could result.
l
Never remove any panel or cover which is secured. The copier
contains high voltage components which can cause electrical shock.
l
Never tamper with the laser mechanism in laser-equipped models, as
blindness or other injury may result.
l
Never drop paper clips, staples or other small pieces of metal through
the vents or other openings in the copier, as a fire or electrical shock
can result.
l
Never place containers of liquid on the copier. If liquids get inside the
copier, they can cause fire or electrical shock. If a piece of metal or any
liquid gets inside the copier, immediately turn the copier off, unplug the
power cord and call your technical representative. A fire or electrical
shock can result if the copier remains plugged in or is operated after
metal or liquid gets inside.
l
Never leave the copier running if it becomes unusually hot, or if smoke
or an unusual odor or noise is detected. Should any of these
conditions occur, immediately turn the copier off, unplug the power
cord and call your technical representative. A fire or electrical shock
can result if the copier remains plugged in under any of these
conditions.
l
Always insert the power plug all the way into the outlet.
l
Always make sure that the outlet is visible, clear of the copier or copier
cabinet.
l
Always provide good ventilation when making a large number of
continuous copies.
l
Never pull on the power cord, and always hold the plug when
unplugging the power cord. A damaged cord could result in a fire or
cause an electrical shock.
l
Never unplug the power cord with a wet hand, as it could cause an
electrical shock.
l
Always unplug the power cord before moving the copier. Moving the
copier with the power cord plugged in can damage the cord resulting
in a fire or causing an electrical shock.

Di250/Di350

X-1