Minolta Di250 Manual page 224

6
Symptom
The copy is blurry.
The copy has lines.
The copy has dark specks or
spots.
The edge of the copy is dirty.
6-2
Possible Cause
The paper is damp.
1074O110
The Original Glass is dirty.
The Original Pad is dirty.
The original is very thin or
highly transparent.
1139O1670A
The original is 2-sided.
1074O111
The Original Pad is dirty.
You have selected a paper
size larger than the original.
(When Zoom Ratio is set at
full size x1.000)
1074O112
The original is not placed in
the correct position (when
the zoom ratio is set at full
size x1.000).
The reduction ratio selected
is not in accord with the copy
paper size. (When doing
manual reduction copying.)
Troubleshooting
Action
Change the paper, see page
5-1.
Wipe the Original Glass
clean with a soft dry cloth,
see page 7-10.
Wipe the Original Pad clean
with a soft cloth dampened
with alcohol, see page 7-10.
Place a blank sheet of paper
over the original,
see page 2-28.
The information on the back
side of a 2-sided, thin original
may be slightly reproduced
on the copy. Set the copier
into the Manual Exposure
mode and, using the [Lighter]
key, make the exposure level
lighter, see page 3-46.
Wipe the Original Pad clean
with a soft cloth dampened
with alcohol, see page 7-10.
Select the same copy paper
size as the original, see page
3-6.
Or, use the Auto Size Mode
to enlarge the copy to the
appropriate size,
see page 3-13.
Select the same copy paper
size as the original. Or,
reload the paper in the same
direction as the original, see
page 2-28 and see page 3-6.
Select the zoom ratio
according to the copy paper
size, see page 3-13.
Or, use the Auto Size Mode
to reduce the copy to the
appropriate size,
see page 3-13.
Di250/Di350