Wpa-Psk / Wpa2-Psk - ZyXEL Communications LTE2566-M634 User Manual

8.3.3 WPA-PSK / WPA2-PSK

Select WPA-PSK / WPA2-PSK from the Security Mode list.
Note: WPA or WPA2 is not available if you enable WPS before you configure WPA or WPA2 in
the Wireless LAN > General screen.
Figure 45 Configuration > Network > Wireless LAN > General: WPA-PSK / WPA2-PSK
The following table describes the labels in this screen.
Table 21 Configuration > Network > Wireless LAN > General: WPA -PSK / WPA2-PSK
LABEL
Security Mode
Encryption
Preshared Key
Group Key Update
Timer
Apply
Chapter 8 WLAN
DESCRIPTION
Select WPA-PSK / WPA2-PSK to enable data encryption.
Select the encryption type of data encryption.
Select AES if your wireless clients can all use AES.
Select TKIP / AES to allow the wireless clients to use either TKIP or AES.
WPA-PSK / WPA2-PSK uses a simple common password for authentication.
Type a preshared key from 8 to 63 case-sensitive keyboard characters.
The Group Key Update Timer is the rate at which the AP sends a new group key out to all
clients.
The default is 3600 seconds (60 minutes).
Click Apply to save your changes back to the LTE2566-M634.
LTE2566-M634 User's Guide
65