Main Menu "System Setup; Setup - Sennheiser SKM 9000 Instruction Manual

Using the EM 9046
50 | Digital 9000
Main menu "System
To get into the main menu:
Select the "sys" operating mode.
In the main menu, you can adjust the following settings:
"Frequency scan" – Performing a frequency scan
Frequency scan
During the frequency scan, the interference levels received by the anten-
nas are recorded and displayed for the booster frequency ranges 1 to 8.
Once you have performed a frequency scan, you can activate
a booster frequency range, assign frequency presets to channels,
adjust the settings to be transferred to your transmitters and syn-
chronize the transmitters and the receiver via infra-red. This chap-
ter provides explanations about all the steps mentioned and, where
necessary, cross-reference to other chapters.
Before performing a frequency scan, carry out the following steps:
Switch off all transmitters that you want to wirelessly connect to the
EM 9046.
Switch on all possible sources of interference (e.g. light sources, inter-
com links, video walls) and all other transmission links.
To perform a frequency scan:
Call up the "Frequency scan" menu item.
The last activated frequency range is highlighted in blue.
G
Turn the jog dial until the text
the screen is highlighted in blue:
Start fullscan
Start frequency scan
B1 B2 B3
0 0
0 0
0 0
0 0
630 654 654 678 670
active
Noise Level Zone HD HD/LR LR/HD
Start the frequency scan by pressing the jog dial G.
Please note: All audio outputs will be muted!
The duration of the frequency scan depends on the number of the
built-in EM 9046 DRX receiver modules. The more modules you use,
the faster the frequency scan is performed.

setup"

"start scan" at the bottom margin of
freq scan
B4 B5 B6
Start scan
0 0 0 0
0 0 0 0
0 0 0 0
0 0 0 0
694 694 718 710 734 734 758 750
start full scan
LR Start scan
freq scan
B7 B8
0 0
0 0
0 0
0 0
774 774 798 MHz
RF IN A B