Sennheiser SKM 9000 Instruction Manual page 65

Digital 9000 system instruction for use
Hide thumbs Also See for SKM 9000:
Table of Contents

Advertisement

Using the EM 9046
64 |
Digital 9000
Press the jog dial.
The infra-red interface
update" menu entry is highlighted in blue:
Antenna booster
Update to firmware:
10-11-30-11
RF IN A:
AB9000_2
Firmware:
10-08-10-10
RF IN B:
AB9000_2
Firmware:
10-08-10-10
Place the infra-red interface of a transmitter in front of the infra-red
D
interface
of the EM 9046.
The currently installed firmware version of the transmitter and the
installable firmware are displayed.
Press the jog dial.
First, the transmitter is read out and
the menu selection of the receiver's display panel. Then, the transmitter
firmware is updated: the infra-red interface flashes faster,
transmitter ... (ca. xx
s)" appears in the menu selection of the receiver's
display panel together with a time specification in seconds. Do not inter-
rupt the infra-red transmission during the update process.
During the update, the following icon appears on the display panel
of your transmitter:
If the firmware update was successful, this icon disappears and
"Transmitter fw update
of the receiver's display panel.
If the update fails, the following icon appears on the display panel of
your transmitter:
In addition, the error message
briefly appears in the menu selection of the receiver's display panel.
In this case, place the infra-red interface of the transmitter in front
of the infra-red interface
mitter firmware without interrupting the infra-red transmission.
To read out and, if necessary, update the firmware of additional transmitters:
Place the infra-red interface of the transmitters in front of the infra-red
D
interface
of the EM 9046, one after the other, and proceed as
described above.
To return to the main menu:
button L.
Press the
esc
D
is activated and flashes blue, the
Transmitter
Start update
Transmitter:
Firmware:
New firmware ...
"Scanning transmitter
successfull" appears in the menu selection
"Error: Transmitter fw update
D
of the EM 9046 and update the trans-
"Start
SCAN MODE
...
...
..." appears in
"Updating
failed"

Advertisement

Table of Contents
loading

Table of Contents