Easy Setup Menu Item; Scan New List; Current List - Sennheiser EK IEM G4 Instruction Manual

Easy Setup menu item

You can scan for unused frequencies using the Easy Setup menu item.
Switch off all transmitters before you perform the scan. If trans-
mitters are still switched on, they are detected as unavailable fre-
quencies and the frequencies that are actually available cannot
then be used.
The squelch threshold setting influences the result. Set the squelch thresh-
old to a low level for as many frequencies as possible, and to a high level
for as many safe frequencies as possible (see "Squelch menu item").
To open the Easy Setup menu item:
▷ Press the SET button on the Home Screen to open the operating menu.
Press the UP or DOWN button until the Easy Setup menu item appears
▷
in the selection frame.
▷ Press the SET button to open the menu item.
▷ Adjust the settings as desired.
►

Scan New List

▷ Select Scan New List to scan for unused frequencies.
Press the SET button to start the scan.
▷
The frequency range of the receiver is scanned. As a result, the number
of unused frequencies is displayed for every frequency bank.
▷ Press the UP or DOWN buttons to select a frequency bank.
▷ Press the SET button to confirm your selection.
▷ Press the UP or DOWN buttons to select an unused frequency from the
selected bank.
Press the SET button to save the changes you made to the settings.
▷
or
Press the ESC button to cancel the entry without saving the settings.
▷

Current List

Select Current List to show the list of unused frequencies from the last
▷
scan.
Using the EK IEM G4
54