Sennheiser SKM 9000 Instruction Manual page 67

Using the EM 9046
66 | Digital 9000
To synchronize the settings with your transmitters via infra-red:
Select one of the channels 1–8.
Switch on the transmitter to which you want to assign this channel.
J
Press the button
The receiver switches to synchronization mode and the
flashes.
Place the transmitter's infra-red interface in front of the infra-red
D
interface of the receiver. Maintain a distance of approx. 10–20 cm
between the infra-red interfaces.
The transmitter and receiver are synchronized:
– After pressing the
searches for a suitable transmitter infra-red signal for 12 seconds.
– You can interrupt the synchronization at any time by pressing the
J
button again.
– If a problem occurs during the synchronization process, read the
chapter "If a problem occurs ..." on page 95.
Repeat the above steps for the remaining transmitters.
on the EM 9046.
button J, the receiver's infra-red interface
B
LED