Sennheiser SKM 9000 Instruction Manual page 56

Using the EM 9046
Adjust the level.
The setting becomes effective immediately.
Press the jog dial to confirm your setting and to return to the channel
selection.
Adjust the level of further channels.
button F. Your settings are stored and the receiver then
Press the
switches to the main menu.
To change to the main menu without storing your settings:
button L.
Press the esc
"Word clock" – Configuring the word clock
internal: 44.1kHz
Via the "word clock" menu item, you can ...
• switch between an internally generated and an external word clock
signal;
• adjust the sampling rate (44.1 kHz, 48.0 kHz, 88.2 kHz or 96.0 kHz)
with which – with an internally generated word clock signal – analog
signals are digitalized and output at the XLR-3 sockets A.
"Cable attn" – Displaying the cable attenuation
RF IN A:
RF IN B:
The EM 9046 receiver measures the cable attenuation between the
antenna boosters and the antenna inputs
compensates for it:
• during the boot routine;
• when an antenna booster is connected.
The "Cable attn" menu item displays the status of the cable attenuation.
Always use GZL 9000 system cables to obtain optimum attenuation
values.
If "Too high" is displayed, check and optimize the installation between the
EM 9046 and the antenna boosters.
word clock
OK
OK
cable attn
H F
and and automatically
Digital 9000 | 55