Extended Menu "Transmitter Setup; Transmitter Setup - Sennheiser SKM 9000 Instruction Manual

Using the EM 9046
Diversity evaluation
Antenna signals
Assess the result of the walk test:
Start fullscan
Showing RF level or channel 1
A
B
0:00 0:30 1:00 1:30
CH 1
790
000
Low antenna signals: RF signal cannot be
evaluated, the window is highlighted in gray
Interference due to extraneous RF signals and low antenna signals can
impede the evaluation of a transmitter's RF signal. In this case, the window
displaying the recorded antenna signals is highlighted in light gray.
Reposition the antennas to minimize interference and to optimize the
reception of transmission signals.
Call up the "RF level recorder" menu item again and repeat the walk
test.
Extended menu "Transmitter
Via the extended menu "Transmitter
ter settings and then synchronize them via infra-red.
The menu items allow you to adjust settings over the entire value range of
the Digital 9000 transmitters. Please note, however, that the actual values
are determined by the hardware configuration of your transmitters
(frequency range, type of microphone head being used (SKM), type of
Sennheiser microphone or cable being used (SK), etc.).
If you adjust settings that are not supported by the transmitters' current
hardware configuration, the value actually adopted by the transmitter is
written back to the menu item of the extended menu
If you transfer a frequency range that is not supported by your transmit-
ter, "Sync Fail" is displayed in the menu selection of the receiver's display
panel.
Modifications made via the
must be synchronized via infra-red.
Modifications made directly on the transmitters have direct effect on the
menu items of the extended menu
For details on the adjustment ranges of your transmitters, refer to the
description of the transmitters' operating menu.
rf level rec
2:00
COMMAND button
has been pressed
setup"
setup", you can adjust the transmit-
"Transmitter
"Transmitter setup" menu item of the EM 9046
"Transmitter setup" of the EM 9046.
RF IN A
RF IN B
no signal
cmd
min
setup".
Digital 9000 | 71