Switching The Receiver On/Off; Using The Em 9046 Receiver - Sennheiser SKM 9000 Instruction Manual

3
44 | Digital 9000

Using the EM 9046 receiver

Switching the receiver on/off

To switch the receiver on:
Make sure the ON/OFF switch
Press the standby button
The receiver's operating system is loaded. During loading, the LED of the
3
standby button flashes red and the display panel shows the
Sennheiser start screen.
Once the operating system is fully loaded, the receiver is in "live" oper-
ating mode.
To switch the receiver to standby mode:
Keep the standby button
display panel goes completely off. The receiver is in standby mode.
To completely switch the receiver off and disconnect it from the mains:
1
Set the ON/OFF switch
All daisy chained signals are interrupted, i.e.:
– the antenna signals at the daisy chain outputs
– the booster supply voltage,
– the signal of the external word clock generator.
Pull out the mains plug from the wall socket to completely disconnect
the receiver from the mains.
1
is set to position "1".
3.
3
pressed for approx. 4 seconds until the
to position "0".
E and H,