Main Menu "System Setup; Setup - Sennheiser Digital 9000 Instruction Manual

Using the EM 9046
56 | Digital 9000
Extended menu "Service setup"
HW setup
Firmware
Main menu "System
To get into the main menu:
Select the "sys" operating mode.
"Frequency scan" – Performing a frequency scan of all 8 frequency
ranges
The main menu contains two menu items that allow you to perform a fre-
quency scan:
1. First, use the "Frequency
able booster frequency range.
2. Then use the "Range detail
sets from the activated booster frequency range to the channels.
Optionally, you can perform a new frequency scan of the activated
booster frequency range.
You can then adjust the settings to be transferred to your transmitters
and synchronize the transmitters and the receiver via infra-red.
Frequency scan
During the frequency scan ("Frequency
levels received by the antennas are recorded and displayed for the booster
frequency ranges 1 to 8.
Before performing a frequency scan, carry out the following steps:
Switch off all transmitters that you want to wirelessly connect to the
EM 9046.
Switch on all possible sources of interference (e.g. light sources, inter-
com links, video walls) and all other transmission links.
To perform a frequency scan:
Call up the "Frequency scan" menu item.
If a frequency scan has already been performed, the last activated
booster frequency range is highlighted in blue.
Displays the hardware
configuration and status
Displays the firmware versions
and updates the firmware of the
transmitters and boosters

setup"

scan" menu item to find and activate a suit-
scan" menu item to assign frequency pre-
scan" menu item), the interference
Page
69
72
freq scan