Sennheiser SKM 9000 Instruction Manual page 55

Using the EM 9046
54 | Digital 9000
To configure your transmitters:
Change to the "ch" operating mode on the EM 9046 (see page 65).
Select one of the channels for which you have stored frequency presets.
Call up the extended menu
mode" menu item.
Adjust the transmission mode ("HD" or "LR") depending on the inter-
ference zone of the channel (see also table on page 52).
Configure your channels as described from page 65 onwards.
Synchronize the transmitters and the receiver as described on page 66.
Repeat for the other channels.
Perform a walk test to check the reliability of your transmission links
(see page 70).
Change the transmission mode for the channels with reception prob-
lems and then synchronize the transmitters and the receiver again.
If the reception problems persist, select a different booster frequency
range.
"Audio output level" – Adjusting the analog output levels
Audio output level
EM 9046 AAO
1 2 3
0 0 0
5 6 7
0 0 0
Analog multicore
0
0
Via the "Audio output level" menu item, you can adjust the level of all or
individual channels of the Analog Audio Out (AAO) module.
Call up the "Audio output
The installed audio modules are displayed as follows:
- digital audio modules:
- analog audio modules:
- not installed audio modules:
Select individual or all channels of the AAO module by turning
the jog dial to the left/right. Selected channels are highlighted
in blue.
Call up the level adjustment by pressing the jog dial. The outer
ring of the channel is highlighted in blue.
If you call up the level adjustment of all channels, the smallest value
adjusted for a channel is displayed in the menu selection. By turning
the jog dial, you can adjust the level of all channels to the value dis-
played in the menu selection.
"Transmitter setup" and then call up the
EM 9046 DAO
4
0
8
0
0
level" menu item.
"Slot digital";
"Slot analog";
"Slot not available".
"RF
output level
0
0