Sram Check; Dram Check - Muratec MFX-1600 Field Engineering Manual

3.13.5 SRAM Check

This mode is used to test the SRAM memory where user programmed parameters such as date, time,
TTI, etc are stored.
Note: When this test is executed, an All RAM Clear will be performed by the unit.
The All RAM Clear erases all user settings and resets all memory switches, machine parameters and
unique switches to factory defaults.
1. Press Program key, *, B(02). Then press One-touch E(05).
SRAM Check
2. Press ENTER .
Note: To finish the operation without performing SRAM check, press STOP .
The data are written to, then read from, each address. The results are shown in the display. If the
read/write test is successful the display will show "OK".
SRAM Check
OK
If some portion of the read/write test fails the display will show "NG" with the address and the data
name.
SRAM Check
NG 00700100H:0000H
3. Upon completion, press any key to return to the standby mode.

3.13.6 DRAM Check

This mode is used to test the DRAM memory, or document memory.
Note: When this test is performed, an All DRAM Clear will be performed by the unit. The All RAM clear
erases all user settings and resets all memory switches, machine parameters and unique switches
to factory defaults.
This is a read/write test that requires a few moments to complete.
Note: Perform a DRAM test whenever a memory upgrade is added to the unit.
1. Press Program key, *, B(02). Then press One-touch F(06).
DRAM Check
2. Depending on the amount of DRAM in the unit, press 0, 1, 2, 3, or 4 on the numeric keypad.
Please refer to the following table:
Note: Usually, press "0".
Press
0 All DRAMs
1 The DRAM on the Main PCB
2 The 8MB Optional Memory PCB (MFX-1200)
or
The first 8MB DRAM on the 24MB Optional Memory PCB (MFX-1600)
3 The second 8MB DRAM on the 24MB Optional Memory PCB (MFX-1600)
4 The third 8MB DRAM on the 24MB Optional Memory PCB (MFX-1600)
Then press START.
Enter/Stop
Check area
3-68