Memory Switch D:2 - Reception; Memory Switch D:3 - Reception - Muratec MFX-1600 Field Engineering Manual

Memory Switch D:2 - Reception

Initial
Switch
Setting
7 0 EYE-Q slice level
0: Disable
1: Enable
6 1 Check EYE-Q
0: No
1: Yes
5 0 Factory use only
4 0 Factory use only
3 1 EYE-Q check level at
2 0 2400 bps
1 1 EYE-Q check level at
0 0 4800 bps

Memory Switch D:3 - Reception

Initial
Switch
Setting
7 0 Factory use only
6 0 Factory use only
5 0 Factory use only
4 0 Factory use only
3 0 Factory use only
2 0 Factory use only
1 0 Delete receive echo of CFR
at the receiver side
0: No
1: Yes
0 0 Expand FSK receive time
after detecting flag
0: 3.3 seconds
1: 10 seconds
Memory Switch D:4
Adjust
Setting this bit to "1" enables memory switch D:2,
bits 0-3 and memory switch D:1, bits 0-7 and
enables EYE-Q check adjustment.
Set at 0: Line condition status (EYE-Q) is not
checked after checking TCF.
Set at 1: Line condition status (EYE-Q) is checked
after checking TCF.
Strict - - - - - - - - - - - -Lenient
Strict - - - - - - - - - - - -Lenient
Adjust
Modem will be opened only in high-speed mode.
Sets this switch to "1" to resolve the problem
caused of the echo of CFR.
Setting this switch to "1" extend HDLC frame
receive timer in FSK from 3.3 seconds to 10
seconds after detecting pre-amble.
D:9 --- Factory use only
3-28
Usage/Comments
0 0 1 1
0 1 0 1
0 0 1 1
0 1 0 1
Usage/Comments