Lcd Error Messages; Lcd Error Messages (Alphabetic List) - Muratec MFX-1600 Field Engineering Manual

4.13 LCD Error Messages

Your fax machine's LCD messages can help you spot problems.

LCD error messages (Alphabetic list)

What you see on the LCD
All Commands In Use
Already Stored
Box In Use
Call For Service
Change to Fax Mode
Check Memory Tx
Check Paper Size
Open&Close Top Cover
Close Scanner Cover
Close Top Cover
Close 1st Side Cover
Close 2nd Side Cover
Close 1st Cassette
Close 2nd Cassette
Communication Error
Copy Off
Dept. Code Full
Document Full
Document Jam
ContStor Enter/Cancl
What it means/ What to do
Your fax machine has all of its 99 possible delayed commands (automatic
redialing counts as one) stored in memory and cannot accept another.
Wait until your fax has completed one of the delayed commands or delete an
existing command by using REVIEW COMMANDS.
You tried to enter the same fax (or phone) number which is already entered
in your fax machine.
Enter a different fax (or phone) number.
You tried to erase a F-Code box which contains at least one document.
Erase the document(s), then try again.
The scanner lamp is dim or inoperable. Make repeated copies to help
evaporate any internal moisture.
See page 4-21.
You tried to to store the document for polling (or for F-Code Box) when the
machine is in the Copy mode. You can store the fax document only when the
machine is in the Fax mode.
You tried to turn the Fax&Copy feature on, but the memory transmission
setting is off. To use the Fax&Copy feature, the memory transmission setting
must be set to on.
Set the Memory Tx to on, then try again.
The difference sized paper which is not same sized paper you told your
sized paper you told your machine is loaded.
Set correct sized paper or change the paper size setting.
The cover indicated on the LCD is open or has not been closed
securely.
Close it properly.
The paper cassette indicated on the LCD is open or has not been
closed securely.
Close it properly.
A communication error disrupted the reception or transmission.
If you were transmitting, press stop to clear the error message and then re-
try the transmission. If you were receiving a fax, try to contact the other
person and have him/her re-try the transmission. (The problem may be
entirely with his/her machine, phone line, etc.)
You tried to change your fax machine to the copy mode, but the unit's copy
protection feature is on, preventing such use.
Turn off copy protection.
You tried to enter department code more than 100. Your machine can store
up to 100 department codes.
You tried to enter an document into an F-Code box, but the machine has
reached its capacity.
Delete documents stored in F-Code boxes until the machine will let you
proceed.
An original document jam while you are using the ADF for either faxing
or copying.
4-13