2. Remove the REAR COVER and OPTION COVER A.
3. Remove the SHIELD PLATE.
4. Remove the CABLE CAP from the CONNECTION CABLE A. Then connect the CONNECTION CABLE
A to the CON2 connector on the PRINTER CONTROL PCB.
5. Connect the CONNECTION CABLE B to the CON1 connector on the PRINTER CONTROL PCB.
6. Insert the PRINTER CONTROL PCB into its slot, while passing the other end of the CONNECTION
CABLE A and B through the rear frame.
7. Plug the other end of the CONNECTION CABLE A to the P14A connector on the MAIN CONTROL PCB.
8. Plug the other end of the CONNECTION CABLE B to the P14B connector on the MAIN CONTROL PCB.
If you are installing the NP-200, connect the NIC PCB to the Printer controller PCB.
Note: The connection cable is not such long actually.
6-14