Presser Foot 2:9; Changing The Presser Foot; Exclusive Sensor System; Changing The Needle 2:9 - Husqvarna Designer Diamond User Manual

Presser Foot

Changing the presser foot

1. Make sure that the needle is in the highest position.
Pull the presser foot down and towards you.
2. Line up the cross pin on the foot with the gap in the
presser foot ankle.
3. Push the foot into the clip until the foot snaps into
place.

EXCLUSIVE SENSOR SYSTEM™

Thanks to the Sensor Foot Pressure, the presser foot
actually senses the thickness of fabric, embroidery or
stitching to sew over it smoothly and evenly with perfect,
fabric feeding.
To see the actual setting of the pres ser foot pressure for
the selected fabric and adjust the presser foot pressure for
specialty techniques, go to the SET Menu (see page 3:6).
Changing the needle
1. Use the hole in the multipurpose tool to hold the
needle.
2. Loosen the needle screw.
3. Remove the needle.
4. Insert the new needle using the multipurpose tool.
Push the new needle upwards with the at side away
from you until it will go no further.
5. Tighten the needle screw.

Lowering feed teeth

Your machine automatically raises or lowers the feed teeth,
depending on the stitch selected. For example, the feed
teeth are lowered when sewing on buttons, or when doing
free-motion sewing and embroidery. The feed teeth are also
lowered automatically when using the Sensor Foot Extra
Lift.
When a new stitch is selected, the feed teeth are
automatically raised again when you start sewing.
Set Up
2:9