To Hoop The Fabric; Slide On The Hoop; Automatic Jump Stitch Trim - Husqvarna Designer Diamond User Manual

To hoop the fabric

For the best embroidery results, place a layer of stabilizer
beneath the fabric. When hooping stabilizer and fabric
make sure that they are smooth and securely hooped.
1. Open the Quick Release (A) on the outer hoop and
loosen the screw (B). Remove the inner hoop. Place
the outer hoop on a rm at surface with the screw on
the lower right (B). There is a small arrow in the center
of the lower edge of the hoop which will line up with
a small arrow on the inner hoop.
2. Place the stabilizer and fabric, with the right sides
facing up, on top of the outer hoop. Place the inner
hoop on top of the fabric with the small arrow at the
bottom edge.
3. Push the inner hoop rmly into the outer hoop.
4. Close the Quick Release (A). Adjust the pressure of
the outer hoop by turning the retaining screw (B). The
fabric should be taut in the hoop for the best results.

Slide on the hoop

Make sure that the accessory tray on the embroidery unit is
closed. Slide the hoop connector into the hoop attachment
from front to back until it clicks into place.
To remove the hoop from the embroidery arm, press the
grey button on the hoop attachment and slide the hoop
towards you.

Automatic Jump Stitch Trim

This machine features Automatic Jump Stitch Trim. This
function saves you time trimming after the embroidery is
completed. As you embroider, the machine will trim the top
jump stitch thread and pull the thread end to the underside
of the fabric.
The default setting is on. To turn it off, go to the SET
Menu, Machine Settings and deselect Automatic Jump
Stitch Trim.
: The machine will also cut the thread after you have changed
NOTE
to a new thread color. When you start embroidering again, hold the
thread end so you can easily remove it after it is cut.
Not all designs are programmed for Automatic Jump Stitch
Trim. Jump stitch trim commands can be added to any
design using the 4D™ Embroidery Software. Read more
about Automatic Jump Stitch Trim in chapter 3.
6:4
Embroidery Set Up
A
B