Table of Contents
Advertisement
Bobbin thread breaks
Did you insert the bobbin properly?
Is the needle plate hole damaged?
Is the bobbin area full of lint?
Is the bobbin wound correctly?
The seam has uneven stitches
Is the thread tension correct?
Are you using too thick or slubbed thread?
Is the bobbin thread evenly wound?
Is a correct needle used?
The machine does not feed or feeds irregularly
Did you thread the machine properly?
Has sewing lint collected between the feed teeth?
Free-Motion setting is on?
The embroidery design is distorted
Is the fabric hooped properly?
Is the inner embroidery hoop completely inserted in the
outer embroidery hoop?
Is the area around the embroidery arm free?
The embroidery design has puckered
Did you stabilize your fabric suf ciently?
The machine will not embroider
Is the embroidery unit attached?
Is the wrong hoop attached?
Have your sewing machine serviced regularly by your local authorized dealer!
If you have followed this troubleshooting information and still have problems, take your sewing machine to your dealer.
If there is a speci c problem, it is a great help to test sew with your thread on a scrap of your sewing fabric and bring it
to your dealer. A sewing sample will often give much better information than words.
Non-original parts and accessories
The warranty does not cover any defect or damage caused by use of non-original accessories or parts.
10:4
Maintenance
Check the bobbin thread.
Change the needle plate.
Clean lint from bobbin area and use only the original
bobbins approved for this model.
Wind a new bobbin.
Check needle thread tension and the threading.
Change the thread.
Check bobbin winding.
Insert a proper needle correctly as described in chapter 2.
Check how the machine is threaded.
Remove the needle plate and clean the feed teeth with a
brush.
Turn off Free-Motion setting in Sewing Settings in SET
menu.
The fabric must be tightly hooped.
Hoop the fabric in such a way that the inner hoop exactly
matches the outer hoop.
Clear area around the embroidery unit.
Ensure you use the proper stabilizer for your technique or
fabric type.
Make sure that the embroidery unit is properly attached
into the socket.
Slide on the correct hoop.
Advertisement
Table of Contents
