Table of Contents
Advertisement
Built-In Designs
Over 150 designs are included in the memory in your
machine and some designs are stored on your USB
embroidery stick. All these designs are also included on the
DESIGNER DIAMOND™ Sampler CD for backup if
you temporarily want to remove them from the machine
memory or USB embroidery stick.
DESIGNER DIAMOND™ Sampler Book
Page through the DESIGNER DIAMOND™ Sampler
book for designs and fonts.
The design number, stitch count (number of stitches in
the design) and the design size are displayed next to each
design. The suggested thread color for each color block is
shown.
Connect the embroidery unit
1.
Slide the sewing accessory tray off.
2.
There is a covered socket at the back of the machine.
Turn the cover to the right to open it. The embroidery
unit plugs into the socket.
3.
Slide the embroidery unit onto the free arm of the
machine until it plugs rmly into the socket. If needed,
use the level adjusting feet so that the machine and
embroidery unit are even. If the machine is turned off,
turn it on.
4.
A pop-up message tells you to clear the embroidery
arm and remove the hoop for positioning. Touch OK.
The machine will calibrate and the embroidery arm will
move to the ready position.
Note: DO NOT calibrate the machine with the embroidery hoop
attached as this can damage the needle, presser foot, hoop and/or
the embroidery unit. Be sure to clear all materials from around the
machine before calibrating so that the embroidery arm does not bump
into anything while calibrating.
Remove the embroidery unit
1.
To store the embroidery unit in the embroidery case,
move the embroidery arm to Park Position by selecting
Park Position on the screen in either Embroidery Edit
or Embroidery Stitch-Out.
2.
Press the button at the left, underneath the embroidery
unit (A) and slide the unit to the left to remove it.
3.
Store the embroidery unit in the original packing
material, place in the soft carrying bag.
Embroidery Set Up
A
6:3
Advertisement
Table of Contents
