Table of Contents
Advertisement
Threading the Upper Thread
Make sure that the presser foot is raised and the needle is
in the up position.
Horizontal Spool Pin
1.
Hold the thread near the spool using your right hand.
2.
Use your left hand to bring the end of the thread over
and behind the Pre-Tension Thread guide (A) and
under the thread guide (B). Bring the thread between
the thread tension discs (C).
3.
Continue threading in the direction indicated by
the arrows. Bring the thread from the right when
threading into the slot on the take-up lever (D).
4.
Take the thread down into the last thread guide (E)
just above the needle.
Needle threader
The needle threader allows you to thread the needle
automatically. The needle must be in the up position to use
the Built-In needle threader. We also recommend lowering
the presser foot.
1.
Use the handle to pull the needle threader all the way
down. The threader hook (G) swivels through the
needle eye.
2.
Place the thread from the back over the hook (F) and
under the thread hook (G).
3.
Let the needle threader gently swing back. The hook
pulls the thread through the needle eye and forms
a loop behind the needle. Pull the thread loop out
behind the needle.
Note: The needle threader is designed to be used for size 70-120
needles. You cannot use the needle threader for needles size 60 or
smaller, the wing needle, twin needle, triple needle or when the Sensor
One-Step buttonhole foot is attached. There are also some optional
accessories that require manual threading of the needle.
When threading the needle manually, make sure that the needle
is threaded from front to back. The bobbin cover can be used as a
magnifying glass to make threading easier.
Set Up
E
F
D
A
C
B
G
F
G
2:5
Advertisement
Table of Contents
