Transfer - Siemens HiPath 1100 User Manual

Functions used during calls
Step by step
Optional (
30

Transfer

The Transfer feature allows an extension to transfer a
call (incoming or outgoing) to another extension or to an
external number.
Required: A call must be in progress.
d
( )
With standard MF telephones, first press the Flash key.
p
Enter the extension or external number.
s
) Let the caller know that there is a second call.
t
Replace the handset.
external-to-external over an analog trunk
When there is an external call in progress, an extension
can make a consultation to another external number
and transfer the call, as described above.
Once the call is transferred and answered at the desti-
nation, a disconnect timer is activated (default is 5 min-
utes). A 20-second warning tone is sent to both parties
before the call is disconnected. In order to continue the
call without disconnecting, the destination number
must enter a code (MF , default "00") to restart the time-
out., The call disconnect timeout and the Code to reset
it are configurable. Please ask your system's support
technician for further information.
If the consultation extension is busy or does not an-
swer, or if you want to return to the first call before
answering...
d
( )
With standard MF telephones, first press the Flash key.
qd
Enter the code for retrieving a call on hold.
w
Wait for the call to be answered.
s
Proceed with the conversation.
[1] If a transfer's destination extension does not answer, the call is re-
turned to the calling extension.
An external-to-external transfer can only be made when at least
one of the calls is an outgoing call.
A call cannot be transferred to an entrance telephone, neither can
an entrance telephone transfer a call.
[2] A call is terminated under three conditions:
• Disconnect timeout after and external-to-external transfer (Code
183);
• When a busy signal is detected;
• Type of answering signal (Code 158) detected.
1
2