Lcr Bypass; Acs - Siemens HiPath 1100 User Manual

Functions used when making calls
Step by step
24

LCR Bypass

This makes it possible temporarily to deactivate the
rules of the LCR for an external call, using the carrier se-
lected by the user to make the connection.
Required: The LCR feature is available.
qhi
Enter the code for "LCR BYPASS".
p
Enter the desired carrier code and number.
s
Start conversation.
End LCR Bypass
t
Replace the handset.

ACS

With ACS (Alternative carrier selection) the system can
be set to use a specific carrier regardless of user's se-
lection. This feature is very useful for selecting the car-
rier that offers the best rates at the time of call or for
setting the system to use one operator only. This is
done by properly defining the rules.
The first digits of the number dialed by the user are an-
alyzed by the system. If they match the conversion rule,
they will be replaced by the default number as set forth
by that rule. You can also preset the route/destination to
be used. There is no field available to specify a carrier.
The carrier code must be included in the conversion
rule.
Different conversion rules can be applied to the same
number, depending on the time of day and day of the
week. It is possible to define a maximum of 100 conver-
sion rules.
Example: Number dialed: 262 XXXX
[1] The rules of the LCR will only be ignored for the current call. If a
consultation or redialing is made, the rules of the LCR will be ana-
lyzed for this new call.
This feature may be activated by any extension.
[2] ACS does not affect emergency numbers when the user dials di-
rectly.
1
2