Wollongong Pathway Access For Dos - Intel EtherExpress PRO/100 User Manual

C H A P T E R 2

Wollongong PathWay Access for DOS

NDIS and ODI Drivers
Wollongong PathWay Access for DOS can be installed using Intel
NDIS or ODI drivers. Installation instructions for both types of driver
are provided below. For information on which driver is appropriate for
your network environment, refer to the Wollongong PathWay Access
for DOS documentation.
Wollongong PathWay NDIS Installation
1 Run the Intel Installation Program from Disk 1, Installation Disk
2 Choose Wollongong PathWay Access from the Select Network
Operating System screen.
3 Follow the prompts to complete the Intel segment of the
installation.
4 Install PathWay Access for DOS Kernel and Drivers programs
according to the instructions in the PathWay Access for DOS
manual. Before rebooting the PC, continue with the following
steps.
5 Use a text editor to modify the CONFIG.SYS file. After the
statement that reads
DEVICE=C:\PATHWAY\PWTCP.SYS
add the lines
DEVICE=\PATHWAY\[PROTMAN FILE] /I:C:\PATHWAY
DEVICE=\PATHWAY\M16ACFG.EXE DRIVER=NDIS
DEVICE=\PATHWAY\M16ANDIS.EXE
where [PROTMAN FILE] is equal to the PROTMAN2.EXE or
PROTMAN.EXE file that is located in your PATHWAY
directory. (Refer to the Wollongong PathWay Access for DOS
manual for information regarding the differences between these
two files.)
6 Copy the files M16ACFG.EXE, M16ANDIS.EXE, and
PROTOCOL.INI from C:\INTEL\M16A directory to the
PATHWAY directory on your hard disk or boot disk.
7 Continue with the "custom" instructions in the PathWay Access
for DOS manual.
8 Reboot the PC.
54