20 Insert the Intel Network Drivers Disk (Disk 2) when prompted.
21 Enter node information when prompted and proceed.
22 A PROTOCOL.INI file created by SETUP will display in edit
mode.
23 Remove the semicolon at the beginning of the ni_irq line, as
follows:
Change the line
;ni_irq = (irq value from step 3)
to read
ni_irq = (irq value from step 3)
The ni_irq value must be the same as the interrupt value used for
the Intel adapter.
24 Verify that the [m16andis] section has the following lines and
settings:
[m16andis]
drivername=intel$
25 Exit SETUP and reboot to start the network. (Some machines may
require a cold boot at this point—power the computer down and
back up again.)
Software Installation
25