Manual Installation; Microsoft Lan Manager - Intel EtherExpress PRO/100 User Manual

Manual Installation

All network drivers provided on the Intel Network Drivers Disk can be
installed manually, without the Intel Installation Program. You must
copy the correct driver files to your hard disk and make appropriate
changes to CONFIG.SYS, AUTOEXEC.BAT, and configuration files
such as NET.CFG (for ODI) or PROTOCOL.INI (for NDIS). Manual
installation should only be performed by a system administrator or
someone with equivalent knowledge of the installation process for your
network operating system.
Note
For manual installation of Novell NetWare with VLM (available
only under MS-DOS or Windows 3.x) you must first decompress
the VLM files by running the MS-DOS batch file
DCOMPVLM.BAT from the Network Drivers Disk, as follows:
DCOMPVLM [ path ]
where [ path ] is the directory for NetWare files (usually
C:\NWCLIENT). DCOMPVLM will decompress and copy all
required files to the designated directory.
For an overview of the installation process, see the instructions
provided for your network operating system in the alphabetical section
of this chapter. Consult Chapter 3, Configuration Reference, for
detailed information on configuration files and settings. For additional
information, consult your network operating system documentation.

Microsoft LAN Manager

Microsoft LAN Manager (version 2.1)
NDIS 2.0 Driver
1 Run the Intel Installation Program from Disk 1, Installation Disk.
2 Choose Microsoft LAN Manager from the Select Network
Operating System screen.
3 Follow the prompts to complete the Intel segment of the
installation.
Software Installation
37