Intel EtherExpress PRO/100 User Manual page 24

C H A P T E R 2
6 Run the SETUP program from the PATHWORKS SETUP disk
for LAN Manager.
7 Choose Configure PC.
8 Choose Network.
9 Select DECnet as transport.
10 When prompted to choose a network adapter, choose "Other."
11 Specify "Intel" as the Adapter Name.
12 When prompted for driver information, use the following:
a. for PATHWORKS 5.0:
NDIS Driver Path: a:\
NDIS Driver File: m16andis.exe
NDIS Driver Name: INTEL$
Other File: A:\M16ACFG.EXE
b. for PATHWORKS 5.1:
Driver file: a:\m16andis.exe
PROTOCOL.INI stub: a:\dec\protocol.ini
Additional Files: A:\M16ACFG.EXE
13 Insert the Intel Network Drivers Disk (Disk 2) when prompted.
14 Enter your node information when prompted.
At this point, the SETUP program will try to connect to the
DECnet server. Once connected, the SETUP program will map a
logical drive to your system service.
15 Highlight the logical drive mapped by the SETUP program, and
press Enter to run PWSETUP.
16 Press Enter to confirm the Software Destination C:\PW.
17 Choose Express (or Custom if you have a lot of prior installation
experience).
18 Select an appropriate Workstation Template, or create one.
19 Under Network Adapter Information, choose other network
adapter, with NDIS enabled, and verify the following information:
Non-Supported Network Adapter
Driver file: a:\m16andis.exe
PROTOCOL.INI stub: a:\dec\protocol.ini
Additional Files: A:\M16ACFG.EXE
24