Intel EtherExpress PRO/100 User Manual page 90

C H A P T E R 4
If the SOCKET keyword was stated, then no PC Card was detected in
the slot specified. If the SOCKET keyword was not used, then no PC
Card was detected in any slot.
Network Controller running in 8-bit mode
Either the driver has determined that the PC hardware does not
support 16-bit mode, or the Network Interface Controller (NIC) has
been forced to run in 8-bit mode with the keyword WORDSIZE set to
8 (default is 16-bit mode).
Network Controller running in I/O mode
Either the driver has determined that the PC hardware only supports I/
O-only mode, and not memory-mapped I/O mode, or the Network
Interface Controller (NIC) has been forced to run in I/O-only mode
with the keyword MODE IO (default is MEM).
Please specify 1, 2, or 3 for the IOWAITSTATES keyword
This message applies to both the ODI and NDIS 2.0 drivers. The value
specified under the IOWAITSTATES keyword in the NET.CFG or
PROTOCOL.INI file must be either 0, 1, 2, or 3.
Please specify 1, 2, or 3 for the MEMWAITSTATES keyword
This message applies to both the ODI and NDIS 2.0 drivers. The value
specified under the MEMWAITSTATES keyword in the NET.CFG or
PROTOCOL.INI file must be either 0, 1, 2, or 3.
Please specify a decimal number for the INTERRUPT keyword
This message applies only to the NDIS 2.0 Driver. The value specified
under the INTERRUPT keyword in the PROTOCOL.INI file must be
a decimal not a hexadecimal number.
Please specify a hexadecimal number for the IOADDRESS keyword
This message applies only to the NDIS 2.0 Driver. The value specified
under the IOADDRESS keyword in the PROTOCOL.INI file must be
a hexadecimal number.
Please specify a hexadecimal number for the MEMORY keyword
This message applies only to the NDIS 2.0 Driver. The value specified
under the MEMORY keyword in the PROTOCOL.INI file must be a
hexadecimal number.
90